Deeper spline has 70% additional height engagement for extra torque capacity and reduced wear

Made from a high-quality AISI 1026 fully machined steel forging

6 High strength weld-on studs will not flex, pull or screw out

Thicker cross-section between studs and lockup surface for a stronger cover, better support of the studs and better heat dissipation

Low surface finish on the lockup surface for consistent lockup and long clutch life

Center thrust area is ground and parallel for use of turbine hubs with bearings

Thrust face-to-lockup surface is the same as OE for more consistent rebuilding

Longer lip to make it easier to reuse impeller covers